Changing
incorrect. The SIM-1-GSXR
speed sensors
, back to the correct reading
The SIM-1-GSXR
to 0.502 times (half).
Calibration is set using the two push button switches. Press the UP button to
increase the speed. Press the DOW
memory which stores the calibrat
work/service on the bike.
*Depending
how far off your speedometer is
on your speedometer with the SIM
miles per hour.
Typical GSXR Install (3-pin
Connection is as follows:
1. Locate the three pin
connector between the speedometer and speed sensor
black connector.
You will need to remove the seat and lift the tank to locate the
under the tank at the back side of the engine with some of the other wiring.
Image 1
2. Unplug the connector.
3. Plug the SIM-1-GSXR
into the two mating connectors. The SIM
between the speedometer and speed sensor. (
4. Re-assemble
any removed pieces and leave the SIM
steps below).
5. Once calibrated s
Wire ties work well for this.
good spot for mounting
SIM-1-GSXR
SPEED RECALIBRATION UNIT
SUZUKI ELECTRIC SPEEDOMETERS
on a motorcycle will make the
an electronic speedometer,
, back to the correct reading
.
table range of correction from 2.84
Calibration is set using the two push button switches. Press the UP button to
increase the speed. Press the DOW
N button to decrease the speed.
memory which stores the calibrat
ion when the bike is turned off, or if the unit is
how far off your speedometer is
, you may NOT
on your speedometer with the SIM
-1-GSXR installed
until you are traveling faster than 5
connectors)
connector between the speedometer and speed sensor
You will need to remove the seat and lift the tank to locate the
under the tank at the back side of the engine with some of the other wiring.
into the two mating connectors. The SIM
-1-
between the speedometer and speed sensor. (
image 3)
any removed pieces and leave the SIM
-1-
GSX accessible for calibration
-1-GSXR
into the harness on the bike so it is not hanging loose.
Wire ties work well for this.
There is a small space in front of the battery
4).
MAN#650310
reading
an electronic speedometer,
with stock electric
(more than double)
Calibration is set using the two push button switches. Press the UP button to
ion when the bike is turned off, or if the unit is
unplugged for any
until you are traveling faster than 5
connector between the speedometer and speed sensor
, typically it is a
You will need to remove the seat and lift the tank to locate the
connector; it is
under the tank at the back side of the engine with some of the other wiring.
(image 1 and 2)
will now be in
GSX accessible for calibration
(see
into the harness on the bike so it is not hanging loose.
under the seat that is a
Comentarios a estos manuales