Dakota Digital 2000 Series Guía para resolver problemas

1 DHC-2000 Digital Height Control System Introduction This control system can be connected to a display module and height sensors or pressure sender

2 INITIAL SETUP The first step is to determine how you want the air control system set up. Is it going to be height based or pressure based? Pressu

3 OPERATION AS AUTO HEIGHT CONTROL SYSTEM The auto height control system is active when both the large red power wire and the yellow accessory powe

4 SETUP SELECTSETUP UPSETUP DOWN Setup Menus: To enter the setup mode, press and hold the left switch on the right hand side (the one closest to the

5 Changing the output speed: The output speed can be used to slow down systems with large air lines or high pressure tanks so that the system will op

6 Troubleshooting guide. IMPORTANT: Make sure to always disconnect the negative cable from the battery if you are going to be working on or under t